HP StorageWorks XP Remote Web Console Software - Manual (Page 128)

4. Right click, and select Check Paths. Selected items appear in blue italics in the WWN tree and
WWN list. The contents of the setting appears in the Preset list.
To check the setting details, right-click the setting in the Preset list, and select Detail. To cancel
the setting, right-click the setting in the Preset list, and select Delete.
5. Click Apply. A confirmation message appears.
6. Click OK.
Changing an external array's port setting
You can change the setting of an external array's port by specifying the WWN that identifies the
external array's port in the WWN list. Use the Change Parameter pane (
Figure 60 ) to change the port
setting.
Figure 60 Change Parameter pane
.
• IO TOV (10-240): Timeout value for the I/O to the external LU. The value can be 10 to 240 (in
second). The default value is 15.
• QDepth (8-128): Number of Read/Write commands that can be issued (queued) to the external
LU at one time. The value can be from 8 to 128. The default value is 8.
• Path Blockade Watch (10-180): Time period beginning when the connection of all paths to the
external LU is down and ending when the external LU is blocked. Commands from the host are
accepted until the time set for this parameter has passed. After the time has passed, the path status
becomes Blockade. The value can be from 10 to 180 (seconds). The default value is 180.
CAUTION:
If there is no problem with the default setting, use the default setting.
CAUTION:
For the external LU used for typical I/O, set IO TOV to 15 seconds.
CAUTION:
To change the setting, match the value to the recommended value for the external array.
To change the setting of the port identified by the WWN by specifying an external array's WWN:
1. In the LU Operation pane, select the WWN tab. The WWN tree and WWN list appear.
Configuring external LUs 128