HP Photosmart C4580 All-in-One Printer - Manual (Page 167)

Product stall error
Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.
• Solution 1: Reset the product
• Solution 2: Contact HP support
Solution 1: Reset the product
Solution: Turn off the product and reset it by disconnecting the power cord. Wait
60 seconds, and then plug in the power cord. Turn on the product.
Cause: You needed to reset the product.
If this did not solve the issue, try the next solution.
Solution 2: Contact HP support
Solution: Contact HP support for service.
Go to:
www.hp.com/support .
If prompted, choose your country/region, and then click Contact HP for information
on calling for technical support.
Cause: There was a problem with the product.
Mechanism error
Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.
• Solution 1: Clear the paper jam
• Solution 2: Remove objects that are blocking the print carriage
Solution 1: Clear the paper jam
Solution: Clear the paper jam and remove any torn paper that remains in the
product.
For more information, see:
“Clear paper jams” on page 114
Cause: The product had a paper jam.
If this did not solve the issue, try the next solution.
Solution 2: Remove objects that are blocking the print carriage
Solution: Lower the print cartridge door to access the print carriage area. Remove
any objects that are blocking the print carriage, including any packing materials. Turn
off the product and then turn it on again.
Chapter 13
164 Troubleshooting
T
roub
les
hoot
ing