HP Photosmart C4580 All-in-One Printer User Manual
Page 23
To print the wireless test report
1.
Press the Wireless button on the product.
2.
Press the button next to the down arrow on the display until Wireless Network
Test is highlighted, and then press OK.
The Wireless Network Test prints.
Related topics
“Network troubleshooting” on page 109
Network configuration page definitions
The network configuration page shows the network settings for the HP All-in-One. There
are settings for general information and 802.11 wireless.
This section contains the following topics:
•
•
Wireless (802.11) network settings
Related topics
•
“Print network settings” on page 19
•
General network settings
The following table describes the general network settings shown on the network
configuration page.
Parameter
Description
Network Status
Status of the HP All-in-One:
•
Ready: The HP All-in-One is ready to receive or transmit data.
•
Offline: The HP All-in-One is not currently connected to the network.
Active connection
type
Network mode of the HP All-in-One:
•
Wireless: The HP All-in-One is connected to a wireless (802.11) network.
•
None: There is no network connection.
URL
The IP address of the Embedded Web Server.
NOTE:
You will need to know this URL when you try to access the
Embedded Web Server.
Firmware
Revision
The internal networking component and device firmware revision code.
NOTE:
If you call HP Support, depending on the problem, you might be
asked to provide the firmware revision code.
Hostname
The TCP/IP name assigned by the installation software to the device. By
default, this is the letters HP followed by the last 6 digits of the Media Access
Control (MAC) address.
Chapter 4
20
Connection information
C
o
nne
ction
info
rmat
ion