HP LaserJet 9050 Printer series - Manual (Page 171)

ENWW Configure device menu 169
DEFAULT PAPER
TYPE PLAIN
PREPRINTED
LETTERHEAD
TRANSPARENCY
PREPUNCHED
LABELS
BOND
RECYCLED
COLOR
CARDSTOCK>163
ROUGH 90-105 G/M2
ENVELOPE
*
Allows the user to specify the type of media in each tray.
Substitute the tray number for
<N> .
* ENVELOPE appears for Tray 1 only.
DEFAULT CUSTOM
PAPER SIZE UNIT OF MEASURE
X DIMENSION
Y DIMENSION Allows the user to set a custom paper size for any of the
installed trays. Substitute the tray number for
<N> . This
menu only appears when the selected tray custom switch
is in the custom size position. The user selects the X and Y
dimensions of the custom paper size using the ruler labels
in the trays.
PAPER
DESTINATION=
STANDARD OUTPUT STANDARD OUTPUT
LEFT OUTPUT BIN
STANDARD TOP BIN Allows the user to configure the output paper bin
destination. Only installed optional bins will appear on the
menu.
DUPLEX=OFF OFF
ON This item appears only when an optional duplex printing
accessory is installed. Set the value to
ON to print on both
sides (duplex) or OFF to print on one side (simplex) of a
sheet of paper.
For more information, see the HP support flyer or go to
www.hp.com/support/lj9050_lj9040 .
DUPLEX
BINDING=LONG
EDGE LONG EDGE
SHORT EDGE Allows the user to change the binding edge for duplex
printing. The menu item is displayed when a duplex
printing accessory is installed in the printer and
DUPLEX=ON .
OVERRIDE A4/
LETTER=
NO YES
NO This command is used to print on letter-size paper when
an A4 job is sent, but no A4-size paper is loaded in the
printer (or to print on A4-size paper when a letter job is
sent, but no letter paper is loaded in the printer).
MANUAL FEED=OFF OFF
ON Feed the paper manually from optional Tray 1, rather than
automatically from a tray. When
MANUAL FEED=ON and
optional Tray 1 is empty, the printer goes offline when it
receives a print job. It then displays
MANUALLY FEED [PAPER
SIZE] .
For more information, see Manually feeding paper from
optional Tray 1 .
EDGE TO EDGE
OVERRIDE=NO NO
YES Turns the edge-to-edge mode on or off for all print jobs.
This mode can be overridden inside a print job by an edge-
to-edge PJL variable.
Item Values Explanation