HP LaserJet 9050 Printer series - Manual (Page 46)

44 Chapter 2 Printing tasks ENWW
7 Set the Custom/Standard switch to Custom.
8 Close the tray.
9 Look at the control panel within a few seconds of closing the tray. (Open and close the tray if
the time has already elapsed.) The control panel indicates the tray size and type settings.
Complete one of the following actions:
• If the size and type settings are correct, press to accept the settings.
• If the size and type settings are not correct, press . The TRAY X SIZE=*<SIZE> menu
appears.
10 To change the size setting, use or to scroll to the correct size and then press . The
message SETTING SAVED appears for a moment, and then the tray type menu appears.
Note Depending on the size that you selected, the printer might prompt you to move the Custom/
Standard switch in the tray to another position. The printer might also prompt you to move the
paper guides. Follow the instructions on the control panel, close the tray, and then repeat this
procedure starting with step 9.
11 To change the type setting, use or to scroll to the correct type and then press .
The message SETTING SAVED appears for a moment, and then the current size and type
settings appear.
12 If the size and type settings are correct, press to accept the settings. The tray is ready to
use.