HP LaserJet 9050 Printer series - Manual (Page 178)

176 Appendix B Control-panel menus ENWW
Embedded Jetdirect submenu
Item Options Values Explanation
TCP/IP ENABLE
HOST NAME
CONFIG
METHOD
DHCP
RELEASE
DHCP RENEW
MANUAL
SETTINGS
ON
OFF
BOOTP
DHCP
AUTO IP
MANUAL
NO
(default)
YES
IP ADDRESS
SUBNET
MASK
SYSLOG
SERVER
DEFAULT
GATEWAY
IDLE
TIMEOUT
Enable the TCP/IP protocol.
Disable the TCP/IP protocol.
An alphanumeric string, up to 32 characters, used
to identify the device. This name is listed on the
Jetdirect configuration page. The default host name
is NPIxxxxxx, where xxxxxx is the last six digits of
the LAN hardware (MAC) address.
Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
Use DHCP (Dynamic Host Configuration Protocol)
for automatic configuration from a DHCP server. If
selected and a DHCP lease exists, DHCP
RELEASE and DHCP RENEW menus will be
available to set DHCP lease options.
Use automatic link-local IP addressing. An address
in the form 169.254.x.x will be automatically
assigned.
Use the MANUAL SETTINGS menu to configure
TCP/IP parameters.
The current DHCP lease along with the leased IP
address are released.
The print server does not request to renew the
DHCP lease.
The print server requests to renew the current
DHCP lease.
The unique IP address of the printer.
The subnet mask for the printer.
The IP address of the syslog server used to receive
and log syslog messages.
The IP address of the gateway or router used for
communications with other networks.
The time period, in seconds, after which an idle
TCP print data connection is closed (default is 270
seconds).