Making booklets – HP LaserJet 9050 Printer series User Manual
Page 68
66 Chapter 2 Printing tasks
ENWW
7
Slide the stapler-unit into the finisher.
8
Close the stapler-unit door.
Making booklets
You can gain access to the booklet-printing feature through some programs, such as desktop
publishing programs. Refer to the user guide that came with your program for information on
making booklets.
If you are using a program that does not support booklet making, you can create booklets by
using your HP drivers.
Note
HP recommends that you use your program to prepare and preview your document for printing,
and hen use your HP driver to print and saddle stitch your booklet.
Use these three main steps to create a booklet from your driver:
●
Preparing your booklet: Arrange the pages on a sheet (booklet imposition) to create a
booklet. You can impose your document from your program or use the booklet-printing
feature in your HP driver.
●
Adding a cover: Add a cover to your booklet by selecting a different first page of a different
paper type. You can also add a cover of the same paper type as your booklet. Booklet covers
must be the same size as the rest of the sheets. However, the covers can be a different
weight from the rest of the booklet. (See
for more information
●
Saddle stitching: Paper must be fed into the printer short-edge first. The printer will ask for
rotated paper. The finisher staples the center of your booklet (saddle stitching). If your
booklet is only one sheet of paper, the finisher will fold the sheet, but not staple it. If the
booklet consists of more than one sheet of paper, the finisher will staple and then fold up to
10 sheets per booklet.