Using the optional multifunction finisher, Output features using the stapler, Output features – HP LaserJet 9050 Printer series User Manual
Page 65: Using the stapler
ENWW
Using the optional multifunction finisher 63
Using the optional multifunction finisher
See the HP LaserJet 9040/9050 Getting Started Guide at
r
more information about the following topics:
●
Stapling documents
●
Saddle stitching
●
Printing booklets
●
Adding a cover to a booklet
Output features
The optional multifunction finisher provides the following output features:
●
Stacks up to 1,000 sheets of A4- and Letter-size paper or up to 500 sheets of A3- and
Ledger-size paper
●
Stacks up to 50 booklets of 5 sheets of A3- and Ledger-size paper
●
Offsets jobs
●
Staples up to 50 sheets of paper per document of A4- and Letter-size paper
●
Staples up to 25 sheets of paper per document A3- and Ledger-size paper
●
Folds single pages
●
Saddle-stitches and folds booklets up to 10 sheets of paper (40 pages)
Using the stapler
The finisher can staple documents consisting of a minimum of two pages, and a maximum of
50 pages of 75 g/m
2
(20 lb) A4- or Letter-size media or up to 25 pages of A3- or 11x 17-size
media or equivalent 6 mm (0.2 inch). The pages must be between 64 and 199 g/m
2
(17 and
53 lb) for any size supported by the product.
Consider these additional points:
●
The stacker can hold up to 1,000 sheets stacked (not stapled).
●
Heavier media might have a stapling limit of fewer than 50 pages.
If the job you want stapled consists of only one sheet, or if it consists of more than 50 sheets, the
finisher delivers the job to the output bin without staples.
Selecting stapling
You can usually select the stapler through your program or driver, although some options might
be available only through the driver. Where and how you make selections depends on your
program or driver.
If you cannot select the stapler from the program or driver, select the stapler from the product
control panel.
1
Press
to open the menus.
2
Use
and
to
scroll
to
CONFIGURE DEVICE
and then press
.
3
Use
and
to
scroll
to
STAPLES
and then press
.
4
Use
and
to scroll to the desired stapling option and then press
.
Your stapling options are
None
,
One
, or
Two
staples.