HP StorageWorks XP Remote Web Console Software - Manual (Page 46)

Installation Requirements and Procedures 46
2-8-3 Partitioning Licensed Capacity and Allocating to SLPR
To partition the licensed capacity and allocate the licensed capacity to SLPR from the License Key Partition
Definition pane:
1. Log on as a storage administrator with either superuser authority or write authority to Disk/Cache Partition
to open the XP Remote Web Console main pane (see Figure 3-1).
2. Change to Modify mode (see section 2-5-1 if you need instructions).
3. Click Install ( ), then click the License Key Partition Definition tab to open the License Key Partition
Definition pane (see Figure 2-32).
4. Select a product from the product list to allocate the license to a SLPR.
5. The Partition Status list (see Figure 2-34) and the Setting box are displayed (see Figure 2-35). Select an
SLPR.
• If the licensed capacity is unlimited, click Enable in the Setting box (see Figure 2-35).
• If the license capacity is limited, type the desired license capacity for the product in the Setting box (see
Figure 2-36).
6. Click Set. The contents of the setting appear in the Remaining Capacity and the Partition Status list.
7. Make additional settings, if desired, using the above instructions.
8. Click Apply to implement the setting, or click Cancel.