Boonton 9240 RF Voltmeter User Manual
Instruction manual, 9240 series, Rf voltmeter
Advertising
INSTRUCTION MANUAL
9240 SERIES
RF VOLTMETER
REV DATE 01/20/2011
MANUAL P/N 98406900A
CD P/N 98406999A
Wireless Telecom Group
25 EASTMANS ROAD, PARSIPPANY, NJ 07054
Telephone: 973-386-9696
Fax: 973-386-9191
Email: [email protected]
Web:
Advertising
Table of contents
Document Outline
- General Information
- Installation
- Getting Started
- Operation
- Zeroing the Instrument
- 4.2 Making Measurements
- Overload Limits
- 4.4 Connection Recommendations
- 4.5 Low Level Measurements
- 4.6 Temperature Effects
- 4.7 Hum, Noise and Spurious Pickup
- 4.8 Recorder Output
- 4.9 Correction Curve for Model 952003 50 Ohm Type N Tee Adap
- 4.10 Correction Curve for Model 952007 75 Ohm Type N Tee Ada
- 4.11 RF Power Measurements
- Remote Operation
- 5.1 GPIB Configuration
- 5.2 RS-232 Configuration
- 5.3 SCPI Language
- 5.4 Basic Measurement Information
- 5.5 SCPI Command Reference
- 5.5.1 IEEE 488.2 Commands
- 5.5.2 CALCulate Subsystem
- CALCulate:LIMit:CLEar[:IMMediate]
- CALCulate:LIMit:FAIL?
- CALCulate:LIMit:LOWer[:POWer]
- CALCulate:LIMit:UPPer[:POWer]
- CALCulate:LIMit:LOWer:STATe
- CALCulate:LIMit:UPPer:STATe
- CALCulate:LIMit[:BOTH]:STATe
- CALCulate:MATH:ARGA
- CALCulate:MATH:ARGB
- CALCulate:MATH:DATA?
- CALCulate:MATH:OPERator
- CALCulate:MODe
- CALCulate:REFerence:COLLect
- CALCulate:REFerence:DATA
- CALCulate:REFerence:STATe
- CALCulate:STATe
- CALCulate:UNITs
- 5.5.3 CALibration Subsystem
- 5.5.4 DISPlay Subsystem
- 5.5.5 FETCh Queries
- 5.5.6 INITiate and ABORt Commands
- 5.5.7 MEASure Queries
- 5.5.8 MEMory Subsystem
- 5.5.9 OUTPut Subsystem
- 5.5.10 READ Queries
- 5.5.11 SENSe Subsystem
- 5.5.12 STATus Commands
- STATus:DEVice:CONDition?
- STATus:DEVice:ENABle
- STATus:DEVice:EVENt?
- STATus:DEVice:NTRansition
- STATus:DEVice:PTRansition
- STATus:OPERation:CONDition?
- STATus:OPERation:ENABle
- STATus:OPERation:EVENt?
- STATus:OPERation:NTRansition
- STATus:OPERation:PTRansition
- STATus:PRESet
- STATus:QUEStionable:CONDition?
- STATus:QUEStionable:ENABle
- STATus:QUEStionable:EVENt?
- STATus:QUEStionable:NTRansition
- STATus:QUEStionable:PTRansition
- STATus:QUEStionable:CALibration:CONDition?
- STATus:QUEStionable:CALibration:ENABle
- STATus:QUEStionable:CALibration:EVENt?
- STATus:QUEStionable:CALibration:NTRansition
- STATus:QUEStionable:CALibration:PTRansition
- 5.5.13 SYSTem Subsystem
- SYSTem:BEEP[:ENABle]
- SYSTem:BEEP:IMMediate
- SYSTem:COMMunicate:GPIB:ADDRess
- SYSTem:COMMunicate:GPIB:EOI
- SYSTem:COMMunicate:GPIB:LISTen
- SYSTem:COMMunicate:GPIB:TALK
- SYSTem:COMMunicate:SERial:BAUD
- SYSTem:COMMunicate:SERial:BITS
- SYSTem:COMMunicate:SERial:PARity
- SYSTem:COMMunicate:SERial:SBITs
- SYSTem:ERRor[:NEXT]?
- SYSTem:ERRor:CODE?
- SYSTem:ERRor:COUNt?
- SYSTem:PRESet
- SYSTem:VERSion?
- 5.5.14 INSTrument:VERSion Commands
- 5.5.15 SCPI Command Summary
- 5.5.16 9230 Emulation GPIB Commands
- Maintenance
- Appendix A SCPI Error Messages
- Appendix B Warranty & Repair