Boonton 9240 RF Voltmeter - Manual (Page 87)

Boonton 9240 Series RF Voltmeter
Table 5-1. SCPI COMMAND SUMMARY (continued)
DISPlay:Label:TEXTD
Displays a text message in the fourth label field.
<alphanumeric value> = A to Z, a to z, 0 to 9 ! @ # $ % ^ & *
( ) _ - + = { } [ ] ? / < > : .
FETCh[1|2]:CW:VOLTage?
Return current average reading in voltage units
FETCh:KEY?
Return code of last key depressed
INITiate:CONTinuous
Set/return state of mode which triggers meas cycles continuously.
<Boolean> = 0, 1, OFF, ON
INITiate[:IMMediate[:ALL]]
Set mode which starts a measurement cycle when trigger event
occurs
MEASure[1|2]:POWer?
Return the average voltage measurement in dBm
MEASure[1|2]:VOLTage?
Return the average voltage measurement in volts.
MEMory[1|2]:SNSR:CWRG?
Return sensor AC cal data.
MEMory[1|2]:SNSR:INFO?
Return the sensor ID and parameter data.
MEMory:SYST:LOAD
Load saved instrument setup by filename.
<character data> = "USER0" ... "USER10".
MEMory:SYST:STORe
Save instrument setup by filename.
<character data> = "USER1" ... "USER10".
OUTPut:RECorder:FORCe
Command sets the Recorder Output voltage to the argument.
<numeric value> = 0.0 to + 10.0 V
OUTPut:RECorder:MAX
Set or return the Recorder Output maximum, or full scale (+10.0V)
voltage reference level.
OUTPut:RECorder:MIN
Set or return the Recorder Output minimum, or downscale (0.0V)
voltage reference level
OUTPut:RECorder:SOURce
Set or return the source channel for the Recorder Output.
<character data> = CH1, CH2, ACTIVE
READ[1|2]:CW:VOLTage?
Return new average reading in voltage units.
SENSe[1|2]:FILTer:STATe
Set/return filter state.
<character data> = OFF, AUTO, ON
SENSe[1|2]:FILTer:TIMe Set or return the current length of the integration filter on the
selected channel. <numeric value> = 0.05 to 20.00 seconds
STATus:DEVice:CONDition?
Return value of Device Condition Register
STATus:DEVice:ENABle
Set/return value of Device Enable Mask
STATus:DEVice:EVENt?
Return value of Device Event Register
Remote Operation
5-37