Supervisor message, Checking the settings (asu), In case the error messaging is disabled (see – Vaisala WMT52 User Manual
Page 103: Wmt52 does not return any re, Supervisor message checking the settings (asu)
Advertising
Chapter 8 ____________________________________________ Sensor and Data Message Settings
VAISALA______________________________________________________________________ 101
Supervisor Message
Checking the Settings (aSU)
With this command you can check the current supervisor settings.
Command format in ASCII and NMEA 0183: aSU<cr><lf>
Command format in SDI-12: aXSU!
The response in ASCII and NMEA 0183:
aSU,R=[R],I=[I],S=[S],H=[Y]<cr><lf>
The response in SDI-12:
aXSU,R=[R],I=[I],S=[S],H=[Y]<cr><lf>
where
a
=
Device address
SU
=
Supervisor settings command in ASCII and NMEA
0183
XSU
=
Supervisor settings command in SDI-12
<cr><lf>
=
Command terminator in ASCII and NMEA 0183
!
=
Command terminator in SDI-12
Advertising