Acknowledge active command (a) – Vaisala WMT52 User Manual
Page 67
Chapter 7 __________________________________________________ Getting the Data Messages
VAISALA_______________________________________________________________________ 65
The response:
b<cr><lf>
Example:
?<cr><lf>
0<cr><lf>
If more than one sensor is connected to the bus, see
. If you need to change the device address, see
Changing the Communication Settings (aXU) on page 59
Acknowledge Active Command (a)
This command is used to ensure that a device is responding to a data
recorder or another device. It asks a device to acknowledge its presence
on the bus.
Command format: a<cr><lf>
The response:
a<cr><lf>
Example:
0<cr><lf>
0<cr><lf>
where
b
=
Device address (default = 0)
<cr><lf>
=
Response terminator.
where
a
=
Device address
<cr><lf>
=
Command terminator
where
a
=
Device address
<cr><lf>
=
Response terminator