Installation procedure, Mounting, Mounting to vertical pole mast – Vaisala WMT52 User Manual
Page 32
User’s Guide ______________________________________________________________________
30 ___________________________________________________________________M210925EN-B
Installation Procedure
At the measurement site, WMT52 needs to be mounted, grounded,
aligned, and connected to the data logger and the power source.
Mounting
Ultrasonic Wind Sensor WMT52 can be mounted either onto a vertical
pole mast or onto a horizontal cross arm. When mounting WMT52 onto
a pole mast, an optional mounting kit can be used to ease mounting.
When using the optional mounting kit, alignment is needed only when
mounted for the first time.
Each of the mounting options is further described in the following
sections.
Mounting to Vertical Pole Mast
1.
Remove the screw cover and insert the WMT52 to the pole mast.
2.
Align the sensor in such a way that the arrow points to north.
3.
Tighten the fixing screw (provided) and replace the screw cover.
NOTE
Ultrasonic Wind Sensor WMT52 must be installed to an upright,
vertical position.