AMETEK 2120 PLC Interface Module - Manual (Page 6)

2 Installation and Programming Manual
Chapter 2: Hardware Overview
Figure 2-1 Interface Module with Resolver/Digital Modules
This chapter contains descriptions of the Interface Module’s components. For installation
instructions, see Chapter 3: Mounting and Wiring.
The Interface Module contains a heavy-duty case which can hold up to fi ve modules. Several
optional modules can be used with the Interface Module. See also Appendix C: Catalog
Numbering System for more information on optional modules.
Power Supply
Controller (CPU)
Digital Output (optional)
Analog Output (optional)
Resolver Input (optional)
Linear Displacement Transducer L1 (optional)
Linear Displacement Transducer V1 (optional)
Relay Output (optional)
The Interface Module’s faceplate contains a 6-digit, seven-segment LED display and four
programming keys. The LED display is used to indicate the position, as well as to display
parameters when programming. The programming keys are used to program the Interface
Module. Ten small status LEDs are also provided. These LEDs are used to indicate the state
of the monitor during machine operation.
Chapter 2: Hardware Overview
AUX3
AUX2
AUX1
PROGRAM
FLT OK
MVT FLT
POS
UPR LIM
LWR LIM
RPM
2120
SERIES
F ( )
3
FMIR01
3
RSLVR
}
7
POWER
FMPS01 FMOR01
4
}
POWER
POWER SUPPLY
100-240VAC 50/60HZ
3
5
6
4
12
RELAY
GND
AUX INP
FLT CHK
L1
L2
Y
A
L
R
E
4
U
FMMP01
2
T
1
C.P.U.
S
V
R
E
L
O
E
R
P
T
O
U
G
T
L
D
2 1
BACK
FRONT