Avaya S8300 - Manual (Page 204)

Installing a new G700 without an S8300 using the Gateway Installation Wizard
204 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
4. Double-click the file name.
The system displays a File Download window.
5. Click on Save this file to disk.
6. Save the file to the C:\tftp directory (or your alternate tftp location).
7. Use WinZip or another zip file tool to unzip the file, if necessary.
Configure the G700
For a new installation of a G700 Media Gateway, you must complete the following configuration
tasks:
Note:
Note:
The Avaya Gateway Installation Wizard (GIW) performs these tasks
automatically.
● Assigning the IP addresses of the G700 media gateway components
- Assigning the IP address for the P330 Stack Processor
- Establishing IP routing for the stack
- Assigning the IP address to the G700 media gateway processor
- Assigning the default IP route to the G700 media gateway
- Assigning IP addresses to the VoIP resources
- Checking for IP connections
● Setting up the media gateway controller list
● Setting the LSP Transition Points
However, the GIW does not configure an X330 Expansion module. This task you must perform
manually, as described in:
● Configure an X330 Expansion Module (If Necessary)
Install firmware on the G700 and media modules
The Avaya Gateway Installation Wizard (GIW) can perform the installation of new firmware on
the G700 and media modules automatically. You identify the specific firmware filenames and the
IP address of the TFTP server. The GIW then performs the following procedures:
● Installing new firmware on the P330 Stack Processor
● Installing new firmware on the G700 Media Gateway Processor
● Installing new firmware on the media modules