Avaya S8300 - Manual (Page 441)

Paging and announcement equipment
Issue 9.1 June 2006 441
Paging and announcement equipment
This section provides information on loudspeaker paging.
On a G700 or G350 Media Gateway, the loudspeaker paging feature is connected through a
port on an MM711 Analog Media Module. The port is administered on the SAT Station screen,
not the Loudspeaker Paging screen.
The G700 or G350 Media Gateway does not support an auxiliary trunk circuit pack. Therefore,
the loudspeaker feature through an auxiliary trunk is not supported on a G700 or G350 Media
Gateway.
Users on a G700 or G350 Media Gateway controlled by an S8700/S8710 or S8500 can also
access the loudspeaker paging feature if equipment is physically connected to a TN763
auxiliary trunk circuit pack in an PN carrier of an the S8700/S8710 or S8500 system.
Figure 48 shows the connections for loudspeaker paging, dial dictation, or recorded
announcement features on a G700 or G350 Media Gateway.
Figure 48: Typical loudspeaker equipment connections for a G700 or G350 Media Gateway
To hook up loudspeaker paging from a G700 or G350 Media Gateway
1. Connect one end of an RJ-45 cable to a port in the MM711 Analog Media Module.
2. Connect the other end of the RJ-45 cable to a customer-supplied telephone hybrid device.
3. Follow the manufacturer’s instructions to properly connect the telephone hybrid device to
your loudspeaker paging system.
4. Administer the M711 port on the SAT Station screen as an analog station.
Note:
Note:
Do not administer the MM711 port on the SAT Loudspeaker Paging screen.
Figure notes:
1. G700 or G350 Media Gateway
2. MM711 Analog Media Module
3. RJ-45 connection 4. Telephone hybrid (third party)
device
5. Loudspeaker paging system
cydfspkKLC 091802
ALM TST ACT
1 2 3 4 5 6 8 7 ALM TST ACT
1 2 3 4 5 6 8 7
REMOVE
ALM TST ACT OK TO SHUT DOWN SERVICES USB 1 USB 2
E1/T1 EIA 530A DCE
ALM TST ACT SIG
EI SO EM SM EO SI
1
2
4
3
5