Avaya S8300 - Manual (Page 517)

Administer Communication Manager
Issue 9.1 June 2006 517
In this section, you will use the SAT interface to:
● Assigning Node Names and IP Addresses for the LSPs
● Administering Network Regions
● Associating LSPs with Network Regions
● Administering IP Interfaces
● Identifying LSPs to the S8300 primary controller
!
CAUTION:
CAUTION:
Before continuing, be sure you have saved translations in Communication
Manager.
Begin by resetting the system.
To reset the System
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6.
2. Log in, and open a SAT session (type sat or dsat).
3. At the SAT prompt, type reset system 4
The system reboots.
4. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specified on the Node Names
screen.
To assign node names
1. At the S8300 SAT prompt, type change node-names ip to open the Node Names
screen.
Example Node Names Screen
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-10-lsp 192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp 192.168.1 _.51_ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___