Avaya S8300 - Manual (Page 569)

Administer Communication Manager
Issue 9.1 June 2006 569
Administering an S8300 primary controller
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
In this section, you will use the SAT interface to:
● Assigning Node Names and IP Addresses for the LSPs
● Administering Network Regions
● Associating LSPs with Network Regions
● Administering IP Interfaces
● Identifying the Survivable Processor on the primary controller
!
CAUTION:
CAUTION:
Before continuing, be sure you have saved translations in Communication
Manager.
Begin by resetting the system.
To reset the System
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6.
2. Log in, and open a SAT session (type sat or dsat).
3. At the SAT prompt, type reset system 4
The system reboots.
4. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specified on the Node Names
screen.
To assign node names
1. At the S8300 SAT prompt, type change node-names ip to open the Node Names
screen.