About connection methods, Connecting a laptop to services port of s8300, Connecting a laptop to the g700 serial port – Avaya S8300 User Manual
Page 63
About connection and login methods
Issue 9.1 June 2006
63
About connection methods
Connecting a laptop to services port of S8300
To connect your laptop directly to the S8300 media server
1. Make sure your laptop meets the hardware and software requirements.
2. Plug an Ethernet crossover cable (MDI to MDI-X) into the 10/100 BaseT Ethernet network
interface card (NIC) on your laptop.
- Crossover cables of various lengths are commercially available.
- See
for pinout connections if needed. Crossover of the transmit and receive pairs
(as shown) is required.
3. Connect the other end of the crossover cable to the Services port on the front of the S8300.
4. If your laptop is configured with the correct network settings, you can now open your
Internet browser or start a Telnet session and log in. When accessing the server from a
directly connected laptop, always type the following IP address in the browser's Address or
Location field to access the server: 192.11.13.6
Connecting a laptop to the G700 serial port
To configure a G700 that does not have an S8300, you may need to set up a direct connection
from your laptop’s serial port to the G700 Console (serial) port.
Table 2: Crossover cable pinout chart
Pin to S8300
Services Port
Connects to
Pin to Laptop
Ethernet card
8
8
7
7
6
2
5
5
4
4
3
1
2
6
1
3