Aalborg SDPROCs - Manual (Page 16)

11
The following display will appear.
Press ESC button under NEXT on the display or the ENTER button under EXIT on the dis-
play, to go back to the Main Display.
e.2.7 Setup Alarm Display
Before enabling the Alarm make sure all alarm settings are configured properly. High
and Low alarm values have to be entered in %F.S. engineering units. ALARM condi-
tions become valid when the difference between current readings and installed set
points is equal or more than corresponding values of high and low alarm levels. From
the Setup Channel Display (see section e.2.6) press the Up button under ALARM on
the display in order to make Alarm settings. The following display will appear.
e.2.7.1 Setup Alarm Mode Display
To change Alarm Mode in ENABLED or DISABLED, press the button (UP, DOWN respec-
tively) directly below the mode shown on the display. Press the ENTER button under EXIT
on the display, to go back to the Main Display. Press the ESC button under NEXT on the dis-
play to go to the Alarm Low settings. The following display will appear.
e.2.7.2 Setup Alarm Low Display
Pressing (+) or (-) will increment or decrement Low Alarm settings per 0.1% F.S. respec-
tively. If no settings required for High Alarm press the ENTER button under EXIT on the dis-
play, to go back to the Main Display. Press the ESC button under NEXT on the display to
go to the Alarm High settings. The following display will appear.
e.2.7.3 Setup Alarm High Display
Pressing (+) or (-) will increment or decrement High Alarm settings per 0.1% F.S. respec-
tively. If no settings are required for High Alarm press the ENTER button under EXIT on the
display, to go back to the Main Display. Press the ESC button under NEXT on the display to
go to the Alarm Delay settings. The following Setup Alarm Delay Display will appear.