Aalborg SDPROCs - Manual (Page 36)

31
e.3.12 Real-time Clock Settings
Real Time Clock Settings Display for SDPROC
Normally date and time for the Real-time Clock are set by the factory, unless the bat-
tery was replaced, or the CPU core was removed from the main board of the SDPROC.
In order to change date and time settings press the ENTER button under SET on the
display. This will activate the flashing cursor on the hours position. Pressing (+) or (-)
will increment or decrement the time settings (hours). When complete with hours set-
tings press again the ENTER button to move the flashing cursor to the minutes posi-
tion. When complete with minutes settings press again the ENTER button to move the
flashing cursor to the seconds position. When done with time settings press again the
ENTER button to move the flashing cursor to the date position (month, date and year)
respectively. When done with years settings press again the ENTER button to disable
Real-time settings and update new time and date.
ƽ Proper settings of the Real-time Clock is essential for the Timer program to be
executed correctly.
When complete with Real-time Clock settings, press the ENTER button under EXIT on
the display, to go to the Main Display screen.
e.3.13 Status Check
While in the Main Display, press the UP button on the front panel of the SDPROC. The
Set point Status in % F.S. for all channels will appear.
Set point Status Display for Multi channel SDPROC
Pressing the UP button again will bring up the Set point Status in current engineering
units for all channels.
Pressing the UP button again will bring up the Valve Mode Status for all channels.
Valve Mode Status Display for Multi channel SDPROC