Aalborg SDPROCs - Manual (Page 4)

e.2.9 Program Settings Display............................................................................
e.2.9.1 Batch Program Settings Display.................................................................
e.2.9.2 Timer Program Settings Display.................................................................
e.2.10 Status Check...............................................................................................
e.3 Multi Channel SDPROC...................................................................................
e.3.1 Start up Display............................................................................................
e.3.2 Main Display...................................................................................................
e.3.3 Channel Select...............................................................................................
e.3.4 Set Point Display............................................................................................
e.3.5 Control Mode Display.....................................................................................
e.3.6 Totalizer/Alarm Status Display.......................................................................
e.3.7 Setup Channel Display....................................................................................
e.3.7.1 Internal/External/Program Reference..........................................................
e.3.7.2 Setup Gas Density Display.........................................................................
e.3.7.3 Setup Engineering Units Display.................................................................
e.3.7.4 Setup Full Scale Flow Rate Display.............................................................
e.3.7.5 Setup Relays Assignment Display...............................................................
e.3.8 Setup Alarm Display.......................................................................................
e.3.8.1 Setup Alarm Mode Display..........................................................................
e.3.8.2 Setup Alarm Low Display............................................................................
e.3.8.3 Setup Alarm High Display...........................................................................
e.3.8.4 Setup Alarm Delay Display..........................................................................
e.3.8.5 Setup Alarm Action Display.........................................................................
e.3.9 Setup Totalizer Display...................................................................................
e.3.9.1 Setup Totalizer Mode Display......................................................................
e.3.9.2 Setup Totalizer Start Flow Display...............................................................
e.3.9.3 Setup Totalizer Stop Volume Display...........................................................
e.3.9.4 Setup Totalizer Action Display.....................................................................
e.3.10 Program Settings Display.............................................................................
e.3.10.1 Batch Program Settings Display.................................................................
e.3.10.2 Timer Program Settings Display.................................................................
e.3.10.3 Ratio Program Settings Display.................................................................
e.3.11
All Valves Control.........................................................................................
e.3.12 Real Time Clock Settings..............................................................................
e.3.13 Status Check.................................................................................................
(f) MAINTENANCE...........................................................................................
(g) ADC/DAC CALIBRATION PROCEDURES.....................................................
g.1 Digital to Analog (D/A) Slope Calibration..........................................................
g.2 Analog to Digital (A/D) Calibration..............................................................
(h) RS-232 SOFTWARE INTERFACE COMMANDS............................................h.1
h.1 General.........................................................................................................
h.2 Commands Structure..................................................................................
h.3 ASCII Commands........................................................................................
14
14
16
17
17
17
18
18
19
19
19
20
20
21
21
21
22
22
22
23
23
23
23
24
24
24
25
25
25
26
27
28
30
31
31
32
32
33
34
35
35
35
37