Activeforever Spa2Go STG-1 - Manual (Page 12)

12
User’s Guide
6. When installing the caps on the infl ation
fi ttings, make sure the sealing fl aps on
the fi ttings are not pulled out through
the infl ation fi ttings. Th is will prevent
the fl aps from sealing properly, and may
damage the infl ation fi ttings.
7. Check the fi t of the nylon outer cover
on the spa. Th e openings in the side of
the nylon skin should be centered on
the power pack connections. If not, let
some air out of the side tubes and adjust
the nylon skin to center the power pack
fi ttings in the openings. Fill all side tubes
until they are just fi rm.
8. Infl ate the infl atable bladder cover. Th ere
are two infl ation fi ttings on the infl atable
bladder cover. Pinch the transparent fi ll
valves while fi lling the cover to ensure
good air fl ow through the valve.
NOTE: After infl ating the spa and
cover, unplug the power pack
while assembling and fi lling
the spa with water.
9. Attach the three feet to the bottom of the
power pack.