Activeforever Spa2Go STG-1 - Manual (Page 7)

Comfort Line Products
7
ADDITIONAL WARNINGS
1. Never use an extension cord to connect the Power Pack to a power source. Th e
cord could cause a voltage drop which may cause damage to the control and
pump motor.
2. Always operate Power Pack with the cord mounted GFCI in place and
functional on 120 volt units. Failure to do so could result in a shock hazard.
3. Always operate spa with suffi cient water. Water level must be above suction
inlets. Insuffi cient water will cause pump failure and void warranty.
4. Maintain proper water pH (7.4 - 7.6 is ideal). Failure to do so may cause
damage to vinyl liner, heater element, and damage will not be covered by
warranty.
5. Install spa only on fl oors or areas that can withstand repeated water exposure.
Equipment failure as well as splashing, fi lling and draining will spill water. If
located in a multi-story building, care must be taken to protect the objects on
the fl oors below.
6. Install only on fl oors that can withstand the fl oor loading of your spa. If in
doubt, please consult an architect or engineer to determine the fl oor rating
before fi ling. See specifi cations.
7. Do not open Power Pack or the GFCI. Opening either component will void the
warranty.
8. When storing, always drain all water from tub, plumbing and Power Pack,
especially in freezing temperature as freeze damage is not covered by warranty.
9. Always maintain proper water sanitation with chemicals and routine cleaning.
Warm water is an ideal place for bacteria to thrive. It’s your sole responsibility
to maintain proper water sanitation. Read the sections on water chemistry and
fi lter maintenance.
10. Never add water to chemicals. Always add chemicals to water to avoid strong
fumes or violent reactions that may result in hazardous chemical spray.
SAVE THESE INSTRUCTIONS