Activeforever Spa2Go STG-1 - Manual (Page 19)

Comfort Line Products
19
MAINTENANCE
Vinyl Care - Interior
1. While the spa is empty, clean the spa interior with a mild soap solution
to remove any soil or stains on the vinyl. Rinse thoroughly before refi lling
the spa. Do not use cleaning aids such as steel wool, metal brushes, or
abrasive cleansers such as Comet or Ajax.
2. Remove and clean the fi lter twice a month, or more often if necessary.
Vinyl Care - Exterior
Clean the exterior with a mild soap solution then rinse with clean water.
Avoid abrasive soaps or tools, or any solvents.
Th e exterior of the spa as well as the thermal top is made to resist mildew and
discoloration.
Recommended Water Chemistry
Purchase a water test kit from your dealer. Test the water chemistry after each
use of the spa, or no less than once a week. Avoid a low pH. Low pH will
cause wrinkles to form in the vinyl, may damage the heater, and will void
your warranty. Th e following are the recommended water chemistry ranges
for your spa.
pH .......................................................... 7.4 - 7.6
Total alkalinity ................................ 80 - 120 ppm
Calcium hardness .......................... 150 - 250 ppm
Bromine residual ................................... 2 - 3 ppm
Total dissolved solids .................. below 1500 ppm
NOTE: If a bromine feeder is used that requires holes to be
punched in the feeder, start with one hole punched at the
top of the feeder and one hole punched at the bottom.
Place the feeder in the spa and test the water after two
days. If the bromine level has not increased to the ideal
2-3 ppm range, punch another hole in the bottom of the
feeder and retest after another two days.