Activeforever Spa2Go STG-1 - Manual (Page 21)

Comfort Line Products
21
Cleaning the Filter
1. Unplug the power pack from the electrical outlet.
2. Using the three caps provided, cap the
suction and discharge fi ttings on the
inside of the spa.
3. Open the air bleed fi tting on the top of
the fi lter tank.
4. Unscrew the retainer ring from the fi lter
housing and remove the fi lter housing
cover.
5. Lift the fi lter out of the fi lter housing.
Clean the fi lter with the spray from a
high pressure garden hose.
6. Place the fi lter back in the fi lter housing.
Make sure the fi lter is properly seated
in the housing and that the o-ring is
properly seated in the o-ring groove.
7. Install the fi lter housing cover and secure
with the retaining ring. Tighten the
retaining ring hand-tight. Do not over
tighten the retaining ring.
8. Remove the caps from the spa suction
and discharge fi ttings inside the spa.
9. Open the air bleed fi tting on the top of
the fi lter housing. Leave the bleed fi tting
open for one minute, or until water drips
from the bleed fi tting. Close the bleed
fi tting.
10. Plug the power pack into the electrical
outlet.
11. Reset the desired temperature set point.
Retaining
Ring
O-Ring
Groove
O-Ring