Activeforever Spa2Go STG-1 - Manual (Page 18)

18
User’s Guide
Turbo Operation
To turn the turbo wave pump on or off , push the on/off button. Look to see
if the spa blows bubbles uniformly all the way around the spa. If action seems
to fade as bubbles circle the spa and are weak on one side, then the lower air
chamber is over-infl ated. Let some air out of the lower chamber to correct
this. Th e turbo wave pump will automatically shut off after 15 minutes of
operation.
When the turbo wave blower system is activated, the blower pump is
pumping outside ambient air into the spa, creating much of the action
in the spa. Some cooling of the water will occur as the turbo wave blower
operates. Th is is normal and the heater will recover lost temperature after use.
Remember, at elevated temperatures, 15 minutes soaking time is considered
safe.
Th e spa power pack contains a fi lter to help keep the water in the spa
clean. If the fi lter becomes dirty or clogged, water fl ow through the power
pack will be restricted. Th is may prevent the spa from heating up. Refer to
the Maintenance section of this manual for information on checking and
cleaning the fi lter.
Cover
After use, place the cover on the spa. Lock the plastic clips in eight locations
on the outside of the spa.
Always leave the cover locked and in place when the spa is not
in use. The cover is not a replacement for adult supervision.
Always supervise young children in and around water.
NOTE: The cover must be in place for the spa to heat up.