Activeforever Spa2Go STG-1 - Manual (Page 4)

4
User’s Guide
IMPORTANT SAFETY INSTRUCTIONS
Th e following instructions are required to be printed by Underwriters
Laboratory (U.L.) as well as ETL Testing Laboratories, Inc. as a condition of
their listing of this product. Th ey contain important safety information, and
we strongly encourage you to read and apply them.
1. When installing and using this electrical equipment, basic safety
precautions should always be followed, including the following:
A. READ AND FOLLOW ALL INSTRUCTIONS.
B. A green colored terminal or a terminal marked G, GR, Ground,
Grounding, or the ground symbol is located inside the supply terminal
box or compartment. To reduce the risk of electric shock, this terminal
must be connected to the grounding means provided in the electric supply
service panel with a continuous copper wire equivalent in size to the circuit
conductors supplying this equipment.
C. At least two lugs marked “BONDING LUGS” are provided on the external
surface or on the inside of the supply terminal box or compart-ment. To
reduce the risk of electrical shock, connect the local common bonding grid
in the area of the hot tub or spa to these terminals with an insulated or bare
copper conductor not smaller than NO. 6 AWG.
D. Temperature Control of your Spa. To set desired temperature, push the
up or down heat button on the display. Th e display will fl ash current
water temperature set point. To raise set point, push up button for each
additional degree of water temperature to a maximum 104ºF (40ºC). Push
the down button to lower the water temperature set point.
2. WARNING - To reduce the risk of injury, do not permit children to use this
product unless they are closely supervised at all times.
3. A wire connector is provided on this unit to connect a minimum No. 8 AWG
(8.4 mm 2 ) solid copper conductor between this unit and any metal equipment,
metal enclosures of electrical equipment, metal water pipe, or conduit within 5
feet (1.5 m) of the unit.
4. DANGER - Risk of injury.
A. If supply cord is damaged it must be replaced by the manufacturer, its
service agent, or similarly qualifi ed persons in order to avoid a hazard.