Activeforever Spa2Go STG-1 - Manual (Page 13)

Comfort Line Products
13
10. Line up the water connections on the
back of the power pack with the fi ttings
on the side of the spa.
11. Remove the two labels from the bottom,
large fi tting of the spa. Make sure the o-
ring inside the fi tting is in place.
12. Attach the bottom, large fi tting on
the back of the power pack to the
corresponding fi tting on the spa, being
careful not to cross-thread the fi tting.
Make sure the o-ring inside the fi tting is
properly seated. Tighten the nut hand-
tight.
13. Attach the middle and upper hose
connections from the power pack to the
spa. Make sure the hose washers are in
place and seated inside the connections.
Tighten the fi ttings hand-tight.
14. Loosen the set screws on the side of the
air loop fi ttings. Insert the air loop onto
the blower connections on the top of the
power pack until snug. Tighten the set
screws.