Activeforever Spa2Go STG-1 - Manual (Page 24)

24
User’s Guide
SERVICE AND TROUBLESHOOTING
Your spa was designed to minimize service requirements. If you encounter
problems with your spa carefully go through the following steps.
Air Pump Blower
1. Turbo wave pump will not turn on:
A. Make sure the power pack is plugged into the electrical outlet, and
that there is power to the outlet. Plug another electrical item into the
outlet such as a hair dryer or lamp. If you do not have power, check
the breakers at the main electrical panel.
B. Test the GFCI per the instructions in the Maintenance section of this
manual. If the GFCI is faulty do not use the spa. Immediately call
your dealer or the factory for instructions. DO NOT BYPASS THE
GFCI! DO NOT USE THE SPA!
2. Turbo wave pump will not turn off : Call the factory for instructions.
3. Turbo wave pump blower trips the GFCI when you turn it on:
A. Take the air loop off the top of the power pack. Look down inside the
left fi tting and see if water has collected inside the power pack.
B. If water has collected inside the power pack, disconnect the large
fi tting connecting the power pack to the spa. Ensure the check valve
in the fi tting is in place and working properly.
4. Turbo wave pump makes a squealing noise: Do not continue running
the turbo wave pump. Contact the manufacturer for instructions.