Samsung HT-C9950W-XAA - Manual (Page 25)

English
25
01
Getting Started
Installing the Product on the Wall
Use the wall mount bracket if you want to install the Control Unit on the wall.
2
Attach the back unit bracket to the Control Unit
using four provided black M4 x L12 screws.
- When you place the bracket on correctly, the
screw holes are indented and the clasps on
the Control Unit mount pass through the two
rectangular holes in the bracket and are fl ush
with the top of the bracket.
2.
1
Place the wall mount bracket in a desired area
of the wall arrow pointing up, and then use
4 screws (not supplied) to fi x it on the wall.
- We recommend attaching the wall mount
bracket to an area of the wall backed by a
stud.
- If there is no stud where you want to attach
the wall mount bracket, use screws with
mollies that can support the weight of the
Control Unit.
1.
3
Fully insert the back bracket’s clasp into the wall
mount bracket receptacle, and then fi x it by
sliding it down fully.
- Later on, you will need to remove the Control
Unit from the wall temporarily to attach the
system cable to the back of the Control Unit.
3.
4
Diagram 4 shows the Control Unit installed
properly on the wall. 4.
HT-C9950W_XAA_0820.indd 25 HT-C9950W_XAA_0820.indd 25 2010-08-20 3:46:11 2010-08-20 3:46:11