Samsung HT-C9950W-XAA - Manual (Page 30)

30
English
Connections
Connecting Speaker Wire
Loosen a knob on the subwoofer by turning counterclockwise.
Match the polarity of the wire to the polarity of the terminal. The
red wire is plus (+) and the black wire is minus (-).
Insert the bare part of the wire into the hole in the side of each
terminal.
Tighten the knob by turning clockwise to secure the wire.
NOTE
Keep the subwoofer speaker out of reach of children to prevent them from inserting their hands or objects
into the duct (hole).
Never touch speaker terminals while the power is on. Doing so could result in electric shock.
Make sure the polarities (+ and -) are correct.
1.
2.
3.
4.
✎



Stretch out the speaker cable and get it through as shown.
NOTE
When installing the front and surround speakers, match the
label color of the stand with the cable color of the speaker.
1.
✎

Installing the Speakers on the Tallboy Stand
Stand Pole
1
Stand Base
Tighten up the screws (large) (3.5x18, x3) as shown.
CAUTION
If you use a torque screwdriver, be careful not to apply
excessive force. You can damage the pole or strip the screws.
(Torque screwdriver- below 84 lbf/in or 15 kgf/cm)
3.
!

3
Fit the stand pole into the stand base.
(if they do not fi t with each other, the stand may get tilted from
an improper installation.) 2.
Stand Pole
2
Stand Base
HT-C9950W_XAA_0826.indd 30 HT-C9950W_XAA_0826.indd 30 2010-08-26 3:08:46 2010-08-26 3:08:46