Samsung HT-C9950W-XAA - Manual (Page 32)

32
English
Connections
CAUTION
Before connecting the speakers, connect the main unit to the subwoofer using the system cable.
See page 26.
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
Keep the subwoofer speaker out of reach children to prevent them from inserting their hands or
alien substances into the duct (hole) of the subwoofer speaker.
Do not hang the subwoofer on the wall through the duct (hole).
Do not insert any other TX cards. Insert only the TX card included with the product.
If you use a different TX card, you can damage your home theater and may not be able to remove
the card easily.
Do not insert the TX card upside down or back side fi rst.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may
cause a problem.
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
If you hear no sound rom the wireless surround speakers, switch the mode to DVD 5.1 channel or
Dolby Pro Logic
II.
If you hear no sound from the surround back speakers, switch the mode to 7.1 channel or Dolby
Pro Logic
II.
In 2-CH mode, no sound eminates from the wireless surround speakers.
NOTE
If you place a speaker near your TV set, screen color may be distorted because of the magnetic
fi eld generated by the speaker. If this occurs, move the speaker away from your TV set.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver
module is too close to the product, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses
the same frequency (2.4/5.8GHz) near the product, you may get some sound interruption due to
interference.
The transmission distance from the product to the wireless receiver module is about 10m, but
may vary depending on your operating environment. If a steel-concrete wall or metallic wall is
between the product and the wireless receiver module, the system may not operate at all,
because the radio wave cannot penetrate metal.
If the product doesn't make wireless connection, the system needs ID Setting between the
product and wireless receiver module. With the product turned off, press the remote control's
number buttons "0"
"1""3""5" and turn on the product. With the wireless receiver module
turned on, press the "ID SET" button on the back of the wireless receiver module for 5 seconds.
!













✎





Attaching the Toroidal Ferrite Core to the Speaker Cable
Open the bigger one of two toroidal ferrite cores by
pulling the lock lever.
Arrange all the speaker cables that are connected to
the subwoofer and make three loops.
Attach the ferrite core as close as possible to the
subwoofer.
Place the toroidal ferrite core on the looped speaker
cable as shown, and then press it closed it until you
hear a click.
1.
2.
•
3.
HT-C9950W_XAA_0820.indd 32 HT-C9950W_XAA_0820.indd 32 2010-08-20 3:46:31 2010-08-20 3:46:31