Bootp, Bootp -14 – ADC Campus-REX RS Interface Card User Manual
Page 126
Internetworking and Management Overview
7-14
Campus-REX RS Interface Card User Manual
You can download product-specific MIBs through the Internet at
ftp.adc.com. Use the following:
•
FTP ftp.adc.com
•
log in using anonymous as your login name
•
use guest or your e-mail address as your user password
•
enter cd /snmp/rex/mib
•
get pgrexmib.txt
BOOTP
BOOTP is used to download configuration information to the Campus-REX
from a BOOTP server. You can also configure these parameters and save
them in NVRAM so that BOOTP can be bypassed. It is recommended that the
BOOTP server be connected to the same segment as the Campus-REX
10BASE-T port.
The Campus-REX supports both local and remote loading of bootstrap
information (IP configuration only) and operational image code. Local
bootstrap configuration information is contained in NVRAM. Local image
code is contained in Flash devices for local loading of operational code.
When loading over the network is preferred, you can use BOOTP (RFC 951)
to obtain bootstrap information and image files. Booting and image download
are controlled by the use of two attributes which are Boot Mode and Image
Load Mode. Other applicable RFCs are:
•
RFC 1533, DHCP Options and BOOTP Vendor Extensions
•
RFC 1542, Clarification and Extensions for the Bootstrap Protocol
(Updates 951)
CAD1069i5.book Page 14 Thursday, May 30, 2002 7:32 AM