ADC Campus-REX RS Interface Card - Manual (Page 56)

Set Up the Campus-REX System
3-28 Campus-REX RS Interface Card User Manual
5 Type then press . The terminal prompts you to enter the
Destination address for the second routing table entry.
6 Repeat steps 2 through 4 . The terminal displays the Bridge/Router
Configuration menu with the first two entries of the routing table filled
in.
7 Type then press . The terminal prompts you to enter the
Destination address for the third routing table entry.
8 Repeat steps 2 through 4 . The terminal displays the Bridge/Router
Configuration menu with the completed routing table.
9 Type then press to return to the Data Port Settings menu.
10 Type then press to write the new bridge configuration to
NVRAM.
11 If you are done making configuration changes, type then press
to reset the Campus-REX and enable the changes. If you plan to continue
making configuration changes, wait until you have finished before
resetting the system.
Make sure you reset the interface card when you have finished
changing bridge/router configuration options. The changes
do not take effect until the system is reset.
1 0 ENTER
1 1 ENTER
R ENTER
3 ENTER
4 ENTER
CAD1069i5.book Page 28 Thursday, May 30, 2002 7:32 AM