ADC Campus-REX RS Interface Card - Manual (Page 36)

Set Up the Campus-REX System
3-8 Campus-REX RS Interface Card User Manual
Using the LCD
The steps in this section use the menu buttons and LCD on the front of the
Desktop Unit or the Campus-Star Campus Management Unit (CMU). The
figure below shows the LCD and menu buttons on the Campus-RS Desktop
Unit. See the Campus-Star User Manual for the location of the LCD and
menu buttons on the CMU. For a complete description of how to use the menu
buttons and LCD, see
“Navigating the LCD Menus” on page 4-2 .
To set the HDSL Transmission Rate:
1 Press Escape until Campus RS I/F: REX displays.
2 Press Next. HDSL LINK CONFIG & STATUS displays.
3 Press Enter. OPERATING MODE displays.
4 Continue with one of the following sections, depending on whether you
are using Standard Mode (
page 3-8 ), Extended Mode ( page 3-9 ), or
AutoSync Mode ( page 3-10 ).
Standard HDSL Mode
This section continues from Step 4 in the previous section to set a Standard
Mode HDSL Rate.
Choose from the following settings:
• T1
• E1
• 768
Next
Enter
Escape
C AMPUS RS
HDSL
Test
Port
LCD Menu buttons
CAD1069i5.book Page 8 Thursday, May 30, 2002 7:32 AM