ADC Campus-REX RS Interface Card - Manual (Page 45)

Set Up the Campus-REX System
Campus-REX RS Interface Card User Manual 3-17
2 To change the Transceiver Mode, type then press . The
Transceiver Mode changes to the next available setting.
Continue with the following steps if the Transceiver Mode is set to
Master. If you set the Transceiver Mode to Slave, you cannot configure
the remaining options on this menu. These settings will be acquired from
the master unit when the HDSL link is established.
3 To change the HDSL Loop Mode, type then press . The HDSL
Loop Mode changes to the next available setting.
4 Type then press . The Select HDSL High Rate (if the HDSL
Loop Mode is set to 1 Loop) or Select HDSL Low Rate (if the HDSL
Loop Mode is set to 2 Loops) menu displays.
ENTER
Dec 9, 1999 ADC DSL SYSTEMS INC., CAMPUS RS, Version x.xx 13:19:32
Local Unit ID: Campus-REX Unit #34 Local I/F: REX
Remote Unit ID: Campus-REX Unit #12 Remote I/F: REX
Circuit ID: Network Extension Circuit 5001
AUTOSYNC MODE HDSL PARAMETERS
1) HDSL Operating Mode: Autosync (Standard, Extended, Autosync)
2) Transceiver Mode: Master (Master, Slave)
3) HDSL Loop Mode: 2 Loops (1 Loop, 2 Loops)*
4) HDSL Rate: 256
*Note:
1 Loop = single loop, full duplex
2 Loops = two loops, full duplex
Remote Unit must be set as Autosync, Slave.
Changes will not be effective until this menu is exited!
(R)eturn (M)ain Menu
ENTER CHOICE>
3 ENTER
4 ENTER
CAD1069i5.book Page 17 Thursday, May 30, 2002 7:32 AM