Entering required snmp parameters, Entering required snmp parameters -8 – ADC Campus-REX RS Interface Card User Manual
Page 84
Configuring with an ASCII Terminal
5-8
Campus-REX RS Interface Card User Manual
2
Type
then press
. The SNMP Configuration menu displays.
3
Continue with the following sections to enter the required parameters
and, if desired, enable authentication error trap generation.
Entering Required SNMP Parameters
To set the required parameters:
1
From the SNMP Configuration menu, type
then press
. The
system prompts you to enter the Read Only Comm String.
2
Type Public, or another string of up to 32 characters then press
.
The SNMP Configuration menu displays.
3
Type
then press
. The system prompts you to enter the Read
Write Comm String.
4
Type Private, or another string of up to 32 characters as prompted then
press
. The SNMP Configuration menu displays.
2
ENTER
May 3, 1999
ADC DSL SYSTEMS INC., CAMPUS RS, Version x.xx
13:18:03
Local Unit ID:
Campus-REX Unit #34
Local I/F:
REX
Remote Unit ID: Campus-REX Unit #12
Remote I/F: REX
Circuit ID:
Network Extension Circuit 5001
SNMP CONFIGURATION
1) SNMP Read Only Community String:
public
2) SNMP Read/Write Community String:
private
3) Authentication Trap Status:
Disabled
(Disabled, Enabled)
4) Trap Receiver 1 IP Address:
0.0.0.0
5) Trap Receiver 1 Community String:
public
6) Trap Receiver 2 IP Address:
0.0.0.0
7) Trap Receiver 2 Community String:
public
(R)eturn
ENTER CHOICE>
1
ENTER
ENTER
2
ENTER
ENTER
CAD1069i5.book Page 8 Thursday, May 30, 2002 7:32 AM