ADC Campus-REX RS Interface Card - Manual (Page 54)

Set Up the Campus-REX System
3-26 Campus-REX RS Interface Card User Manual
6 Type then press . A prompt displays, asking you to enter the
default router IP address. This address defines the next hop default router
for the Campus-REX to use to route packets that have a destination
address that is not in the IP Static Routing Table.
7 Type the address, in decimal-dotted notation then press .
8 Continue with the following sections.
Entering Port Addresses
This section describes how to enter the port addresses for the Campus unit.
There are two port addresses:
• The LAN Port IP address is the IP address for the 10BASE-T port on the
Campus-REX.
• The Line Port IP address is the IP address for the HDSL port on the
Campus Desktop Unit or Campus-Star chassis. If the HDSL line
connects two Campus-REX units, this address is hidden from the rest of
the network. In this case, you can assign artificial parameters to the Line
Port, although the Line Port addresses must belong to the same IP subnet.
1 From the Bridge/Router Configuration menu, type then press .
The terminal prompts you to enter the LAN IP Address.
2 Type the address, in decimal-dotted notation, then press . The
new address displays.
3 Type then press . The terminal prompts you to enter the LAN
Subnet Mask.
4 Type the mask, in decimal-dotted notation, then press . The new
subnet mask displays.
5 Type then press . The terminal prompts you to enter the Line
IP Address.
6 Type the address, in decimal-dotted notation, then press . The
new address displays.
8 ENTER
ENTER
4 ENTER
ENTER
5 ENTER
ENTER
6 ENTER
ENTER
CAD1069i5.book Page 26 Thursday, May 30, 2002 7:32 AM