Acnodes RACKMOUNT SYSTEM RMC 7189 - Manual (Page 25)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7189
1U Rackmount System
3-3 Control Panel LEDs
The control panel located on the front of the chassis has five LEDs. These LEDs provide you with critical
information related to different parts of the system. This section explains what each LED indicates when
illuminated and any corrective ac- tion you may need to take.
Universal Information LED
When this LED blinks red quickly, it indicates a fan failure and when blinking red slowly a power failure.
This LED will be blue when used for UID (Unit Identifier). When on continuously it indicates an overheat
condition, which may be caused by cables obstructing the airflow in the system or the ambient room
temperature being too warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers are installed. Finally,
verify that the heatsinks are installed properly (see Chapter
5). This LED will remain flashing or on as long as the indicated condition exists.
See the table below for descriptions of the LED states.