Acnodes RACKMOUNT SYSTEM RMC 7189 - Manual (Page 87)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7189
1U Rackmount System
Gateway Address
The BIOS will automatically enter the Gateway address of this machine; however it may be over-rid-
den. IP addresses are 6 two-digit hexadecimal numbers (Base 16, 0 ~ 9, A, B, C, D, E, F) separated
by dots. (i.e., 00.30.48.D0.D4.60).
Mac Address
The BIOS will automatically enter the Mac address of this machine; however it may be over-ridden.
Mac addresses are 6 two-digit hexadecimal numbers (Base 16, 0 ~ 9, A, B, C, D, E, F) separated by
dots. (i.e., 00.30.48.D0.D4.60).
XSet PEF Configuration
Set this feature to configure the Platform Event Filter (PEF). PEF interprets BMC events and performs
actions based on pre-determined settings or 'traps' under IPMI 1.5 specifications. For example, pow-
ering the system down or sending an alert when a triggering event is detected.
The following will appear if PEF Support is set to Enabled. The default is Dis- abled.
PEF Action Global Control - These are the different actions based on BMC events. The options are
Alert, Power Down, Reset System, Power Cycle, OEM Action, Diagnostic Interface.
Alert Startup Delay - This feature inserts a delay during startup for PEF alerts. The options are En-
abled and Disabled.
PEF Alert Startup Delay - This sets the pre-determined time to delay PEF alerts after system power-
ups and resets. Refer to Table 24.6 of the IPMI 1.5 Specification for more information at
www.intel.com. The options are No Delay, 30 sec, 60 sec, 1.5 min, 2.0 min.
Startup Delay - This feature enables or disables startup delay. The options are Enabled and Dis-
abled.
PEF Startup Delay - This sets the pre-determined time to delay PEF after system power-ups and
resets. Refer to Table 24.6 of the IPMI 1.5 Specification for more information at www.intel.com. The
options are No Delay, 30 sec, 60 sec, 1.5 min, 2.0 min.
Event Message for PEF Action - This enables of disables Event Messages for PEF action. Refer to
Table 24.6 of the IPMI 1.5 Specification for more informa- tion at www.intel.com. The options are
Disabled and Enabled.
BMC Watch Dog Timer Action
Allows the BMC to reset or power down the system if the operating system hangs or crashes. The
options are Disabled, Reset System, Power Down, Power Cycle.