Acnodes RACKMOUNT SYSTEM RMC 7189 - Manual (Page 47)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7189
1U Rackmount System
Power Fail LED
The Power Fail LED connection is located on pins 5
and 6 of JF1. Refer to the table on the right for pin
defini- tions.
Reset Button
The Reset Button connection is lo- cated on pins 3
and 4 of JF1. Attach it to the hardware reset switch
on the computer case. Refer to the table on the right
for pin definitions.
Power Button
The Power Button connection is located on pins 1
and 2 of JF1. Mo- mentarily contacting both pins will
power on/off the system. This button can also be
configured to function as a suspend button (see the
Power Button Mode setting in BIOS). To turn off the
power when set to suspend mode, depress the
button for at least 4 seconds. Refer to the table on
the right for pin definitions.
Universal Serial Bus Ports
Two Universal Serial Bus ports are located on the I/
O backplane. USB0 is the bottom connector and
USB1 is the top connector. Two Type A ports (USB6
and USB7) are also included on the serverboard
(see board layout for locations) See the table on the
right for pin definitions.