B. interface specifications, B.1 parallel interface – AMT Datasouth documax 3300 User Manual
Page 137
User’s Guide
Interface Specifications B-1
B. Interface Specifications
B.1 Parallel Interface
•
Data Transmissions:
7 or 8 bit
•
Synchronization:
Externally supplied Data Strobe
•
Handshaking:
Acknowledge (Busy before Acknowledge or Busy after Acknowledge)
Busy (Acknowledge before Busy or Acknowledge after Busy)
•
Logic Level:
Input data and all interface signals are TTL compatible.
Two output signals control the handshaking on the parallel interface, the BUSY signal
and the ACKNOWLEDGE signal. An incoming DATA STROBE will cause BUSY to
go high.
PAPER END:
The PAPER END signal is an active high signal that will go high
when paper out is detected.
ERROR:
The ERROR signal will go low with the detection of an error
condition. A fatal printer error condition exists when ERROR is low,
PAPER END is low and SELECT is high.
SELECT:
When the printer is ready to receive data, the SELECT signal is set
high. This signal will go low when:
The On/Off Line key is pressed.
There is a carriage jam.
Paper out is detected.
Fatal errors.