AMT Datasouth documax 3300 - Manual (Page 65)

User’s Guide
Forms Handling 3-19
b. Press the Next Menu key to access Menu 8, Form Thickness.
c. Press Feature ▼ key to obtain this display.
4. Use the Value keys to adjust the form thickness gap. Form thickness setting will be
stored in memory.
a. Press the Value ▲ key once or twice to reduce the form gap (moves the printhead
closer to the form) if there is light print.
b. Press the Value ▼ key once or twice to increase the form gap (moves the printhead
away from the form) if there is smudging, smearing or paper handling issues.
5. Once the adjustment has been made using the keypad, the printer will store the setting
in memory only in the selected profile. The printer will continue to use this gap setting
the next time forms are loaded.
M8 FORM THICKNESS
Adj Form Gap XX
NOTE
There is no direct correlation between form
thickness position and number of parts in a
multi-part form (e.g. adjustment control is
not set to the fourth mark for a four-part
form). Multi-part carbonless forms must be
given time to cure before being separated to
prevent light print quality. (Contact paper
supplier for cure times.)