AMT Datasouth documax 3300 - Manual (Page 72)

User’s Guide
3-26 Forms Handling
3.11 Automatically Changing Paper Paths On Paper Out
The printer may be configured to automatically change paper paths during a paper out
condition.
After changing paths, the printer will attempt a load. If paper is found, printing will continue.
If no paper is installed, the unit will stop and indicate a paper out condition.
To enable this feature:
1. Open Keypad Door.
2. Press the Next Menu key until Menu 4 is displayed.
3. Press Feature ▲ until feature is displayed.
4. Press Value ▲ ▼ to turn the feature on, and then press the Enter key to save selection.
5. Close Keypad Door and press the Profile key to save profile.
NOTE
This may be useful in applications where the
printer is unattended or installed at a remote
location. If this feature is enabled, the same
forms must be loaded in both paper paths.
M4 PRINTER CNTRL
Auto Path SW Off