AMT Datasouth documax 3300 - Manual (Page 16)

User’s Guide
1-2 Keypad Configuration
1.2 Quick Start Up Procedure
The following is an abbreviated installation and start up procedure provided for users who are
already familiar with printer products. If you are not experienced with printers, follow all the
instructions in Chapter 1 for setting up the printer.
1. Place the printer on a suitable stand or countertop.
2. Install ribbon cartridge and power cord.
3. Turn printer on
4. Position left tractor with ‘Alignment’ mark on printer. Position front paper guides and
rear paper supports equally across the width of the form. Load 8 ½” paper into
tractors. (For cut sheet forms, set the left cut sheet guide to “0” and insert 8 ½” paper).
5. Press the Load Key (unnecessary for cut sheet path).
6. Open Keypad Door to enter Setup Mode.
7. Use the Quick Access Key, the Value ▲▼ keys, and the Enter Key to set margins.
8. Close the Keypad Door.
9. Press the Profile Key to save settings.
10. Open Keypad Door.
WARNING
CONNECT 115V UNITS TO 115V
OUTLETS ONLY! PRINTER DAMAGE
WILL RESULT!