Allied Telesis AT-FS970M Series - Manual (Page 388)

Chapter 20: MAC Address Table Commands
388
SHOW MAC ADDRESS-TABLE
Syntax
show mac address-table begin|exclude|include [interface
port ]|[vlan vid ]
Parameters
begin
Specifies the first line that matches the MAC address is displayed.
The address must be specified in either one of the following
formats: xx:xx:xx:xx:xx:xx or xxxx.xxxx.xxxx
exclude
Indicates the specified MAC address is excluded from the display.
The address must be specified in either one of the following
formats: xx:xx:xx:xx:xx:xx or xxxx.xxxx.xxxx
include
Indicates the specified MAC address is included in the display. The
address must be specified in either one of the following formats:
xx:xx:xx:xx:xx:xx or xxxx.xxxx.xxxx
port
Specifies a port. You may specify more than one port.
vid
Specifies a VID. You may specify one VID.
Modes
Privileged Exec mode
Description
Use this command to display the aging timer and the unicast and multicast
MAC addresses the switch has stored in the table. You may view all of the
addresses in the table or only the addresses learned on a particular port or
VLAN.
In addition, the software supports a GREP feature which allows you to
specify a MAC address that is displayed or a MAC address that is not
displayed by this command. You can also display MAC addresses that
begin with a specified value.