ALFA OKIPAGE 20 - Manual (Page 33)

Chapter 3: The Printer Menus E–25
DUP ADJ
0mm ( Range +2.00 to –2.00 mm, in 0.25 mm
intervals)
Notes: For the OKIPAGE 20, this setting only
applies when the optional Duplex
Feeder is installed.
Adjust vertical print position in 0.25
mm increments. Plus (+) indicates
downward movement, minus (–)
indicates upward movement.
In PostScript mode, any negative
values selected will be ignored.
2ND TRAY
5 ( Range 1 to 16)
Notes: Applies only when the optional Paper
Expansion Tray is installed. Sets the
priority of the optional tray in the HP
PCL 6 emulation.
3RD TRAY
9 ( Range 1 to 16)
Notes: Applies only when two optional Paper
Expansion Trays are installed. Sets the
priority of the second optional tray in
the HP PCL 6 emulation.
FRONT
4 ( Range 1 to 16)
Notes: Sets the priority of the Manual Feeder
in the in the HP PCL 6 emulation.
PLACE PG
CENTER
LEFT
Notes: Sets placement of printed image on the
page.
SETTING
0 ( Range –1 to +1 in increments of 1)
Notes: Adjust to improve print quality:
–2 Rough/thick papers and/or low
temperature/humidity
–1
0 Normal media/environmental
conditions
+1
+2 Rough papers and/or high tem-
perature/humidity
CLN CYCL
NORMAL
MIDDLE
HIGH
Notes: Sets the frequency of the page cleaning
sequence:
NORMAL = every 20 pages
MIDDLE = every 10 pages
HIGH = every 3 pages.