ALFA OKIPAGE 20 - Manual (Page 9)

English–1
Chapter 1: Setting Up
This chapter explains how to unpack and install your printer.
Select a Suitable Location
Before unpacking your printer, select a suitable location for it which meets
the following criteria:
• A firm, level surface, such as a table or desktop
• Clearance to open the cover, the paper tray, and the rear paper exit
extender
• Air circulation around the printer to prevent overheating (recommended
minimum of 4" in all directions)
• A nearby power source
• Room temperature of 50° to 90°F (10° to 32°C)
• Relative humidity of 20-80%
• No direct sunlight
Unpack
Your printer
1.
Unpack the printer and place it on the surface you’ve selected.
2. Remove the printer from the plastic bag.
3. Lift up the corner of the protective film and peel it off the control panel.
The accessories
As you unpack the accessories, please save the packing material in the event
you need to repack the printer for shipping.
Important! Be sure to store the black light-shield bag near the printer to
protect the image drum in case you need to take it out of
the printer for more than a minute or so. This bag is also
used to store the image drum in case you need to ship the
printer.
Check the contents
➊ OKIPAGE 20 Printer
➋ Toner Cartridge with LED lens
cleaners
➌ Power Cord
➍ Software Support CD
➎ Software Support
Diskette
➏ Light-shield bag
If you are missing
anything, contact your
dealer.
You will need to purchase:
• Paper (see page 5)
• Interface cable: either bi-directional IEEE-1284 parallel cable (see page
9) or RS232-C serial cable (see page 11)
➊
➋
➌
➍
➏
➎